Reset Toner and Drum HL-L6200
APPLIES TO HL-L5000D/HL-L5100DN/HL-L5200DW/HL-L5200DWT/HL-L6200DW/HL-L6200DWT
THE BELOW PROCEDURES WILL NOT WORK IF DATA IS PENDING.
Please press cancel until no jobs are pending.
DRUM RESET
- Make sure the machine is turned on.
- Open the front cover.
- Press and hold OK for about two seconds to display the [Drum Unit] option, and then press OK.
- Press for [Reset] to reset the drum counter.
- Close the front cover of the machine.
TONER RESET
- Open the front cover and leave open while completing the following steps.
- Push both the SECURE and CANCEL buttons at the same time.
- Use the UP and DOWN arrow to reset the type of toner you have.
- Push OK to reset selected toner counter.
- When you see ACCEPTED on the display the count is reset.
- Close the front cover
FUSER/LASER RESET
Only perform is there are not any printing issues- Press OK key
- Press GO key
- (screen goes blank)
- Press up arrow 4 times
- (Maintenance flashes)
- Press Down until Maintenance 88
- Press OK
- Choose Reset-Laser or Reset-Fuser
- Press OK
- Reboot Printer